Removing and installing actuator for differential lock — AUDI

🧭 Before you start

Fits: VW Transporter T5 (7H), VW Transporter T5 (7J), VW Transporter T6 (7E), VW Transporter T6 (7F)

📋 Procedure

1. Detach brackets for front and rear silencer from body.
2. Place exhaust system onto anti-roll bar.
3. Place engine and gearbox jackV.A.G 1383 A or engine and gearbox jackVAS 6931 under final drive.
4. Unscrew bolts (1).
5. Lower final drive, until propshaft rests slightly on anti-roll bar.

6. Disconnect connector (2) from actuator for differential lock (1).
7. Unscrew bolts (2).
8. Pull vacuum hoses off actuator.
9. Detach bellows (1) from actuator for differential lock.
10. Pull off retaining ring (2).
11. Pull pin (3) out of actuator for differential lock (1).
12. Remove actuator for differential lock (1) from final drive.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures