Removing and installing accelerator module, engine codes BGU, BSE, BSF, CHGA — AUDI
Removing and installing accelerator module, engine codes BGU, BSE, BSF, CHGA on Audi: 10 steps, 1 torque figure, engines BCA, BGU, BSE, BSF.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Caddy III (2K, 2004–2015); platform code 2C0
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 10 Nm (7.4 lb-ft) | Secure accelerator module with bolt (3) and tighten to specified torque |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Remove cover for steering column (arrows).
- Lever cover cap out with a screwdriver.
- Unscrew securing bolt .
- Push release tool T10238 (for right-hand drive vehicles release tool T10240) into intended holes to stop as shown. Remove accelerator module.
- Disconnect electrical connector and pull off line routing from accelerator module.
- Connect line routing (1) and electrical connector (2) to accelerator module.
- Push accelerator module onto securing pins (6).
- Insert centring pin (7) into bore on vehicle floor.
- Secure accelerator module with bolt (3) and tighten to specified torque of 10 Nm. Fit cap (4). — 10 Nm (7.4 lb-ft)
- Install cover for steering column again.
Other AUDI procedures
- Sealing upper and lower covers
- Removing and installing tank pressure sensor G400
- Part I: assembly overview - toothed belt drive
- Assembly overview - parts of cooling system (radiator with two fans), body side
- Assembly overview - part I, belt drive
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.