Removing and installing 6-position connector point, A-pillar (passenger's side) — AUDI
Removing and installing 6-position connector point, A-pillar (passenger's side) on Audi: 10 steps. What to remove, in what order, and what to check after.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi A4 B8 (8K, 2007–2015)
Don't miss
- The exact contact assignment for the 6-position connector point in the A-pillar (passenger's side) can be found in the applicable current flow diagram .
📋 Procedure
- With ignition switched off, disconnect earth cable at battery .
- Remove A-pillar trim (bottom right) General body repairs, interior70Passenger compartment trim panels; Removing and installing A-pillar trim.
- Press retaining clip in direction of (arrow) and detach connector point (1) from A-pillar.
- Unclip fuse holder (2) at connector point.
- If fitted, unplug electrical connector (2) for airbag .
- Pull out relays and control units.
- Release retaining clips (arrows) and press out relay carrier (2) towards rear out of holder (1). [Note: The exact contact assignment for the 6-position connector point in the A-pillar (passenger's side) can be found in the applicable current flow diagram .]
- Plug in electrical connector for airbag .
- Install A-pillar trim (bottom right) General body repairs, interior70Passenger compartment trim panels; Removing and installing A-pillar trim.
- Connect battery. Steps required .
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Removing and installing operating unit (Climatronic control unit J255) - automatically controlled air conditioner
- Checking fuel system pressurisation pump G6/fuel pump G23, vehicles with 6.0 ltr. (V12) engine
- Removing and installing throttle valve module J338
- Exploded view of wheel bearing housing, wheel bearing unit, trailing arm with mounting bracket, stone deflector
- Removing and installing subwoofer in rear shelf R157, high-voltage vehicles
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.