Checking oil level for Haldex coupling, Haldex generation IV — AUDI
Checking oil level for Haldex coupling, Haldex generation IV on Audi: 10 steps. What to remove, in what order, and what to check after.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi A1 (8X, 2010–2018), Audi Q3 (8U, 2011–2018); platform code 84
📋 Procedure
- With ignition switched off, connect to diagnostic connection (arrow).
- Switch on ignition.
- Select the options on the tester in this sequence:
- Identify vehicle using Guided Functions.
- Select 22 - 4WD electronics/22 - Haldex4.
- Select Coupling temperature/Control unit temperature.
- Read off oil temperature.
- Position drip trayVAS 6208 under final drive.
- To check oil level, unscrew oil inspection plug (2). (For illustration purposes here shown with final drive removed.)
- If necessary, top up with high-performance oil for Haldex couplingFilling up high performance oil for Haldex coupling.
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.