Checking automatic gearbox relay J60: Audi A4 Cabriolet B6/B7 / A4 B6/B7

🧭 Before you start

Fits: Audi A4 Cabriolet B6/B7 (8H), Audi A4 B6/B7 (8E)

📋 Procedure

1. Remove automatic gearbox control unit J217 and lay it aside with connector attached.
2. Turn ignition key to "“start”" position.
3. Move selector lever from "“S”" to "“P”" and back to "“S”".
4. If relay does not pick up, check voltage supply .
5. If relay picks up but starter does not turn, check wiring from automatic gearbox relay J60 to starter (terminal 50), or check starter according to current flow diagram.

6. Pull out automatic gearbox relay J60.
7. Connect voltage testerV.A.G 1527B as follows:
8. Turn ignition key to "“start”" position.
9. If LED does not light up, check wiring .
10. Connect voltage testerV.A.G 1527B as follows:
11. Move selector lever from "“S”" to "“P”" and back to "“S”".
12. If LED does not light up, check selector mechanism and adjustment of selector lever cable .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing fuel delivery unit/fuel gauge senders - TDI vehicles
• Removing and installing brake cable (rear) – Audi A1
• Checking fuel pressure – Audi 2.0
• Removing and installing fuel gauge sender 2G169 - A5 from model year 2012 onwards, A4 from model year 2013 onwards, rest-of-world vehicles with four-wheel drive, USA vehicles with front-wheel drive/four-wheel drive
• Removing and installing rear axle - front-wheel drive vehicles