Brake system — Removing and installing contact switch for handbrake — AUDI

🧭 Before you start

Fits: Audi A4 Cabriolet B6/B7 (8H), Audi A4 B6/B7 (8E)

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Remove centre console extension 68.
2. Release handle (1) with a screwdriver (3) and remove.
3. Remove cover (4) and handle (1).
4. Unscrew hexagon bolts (2) and remove carrier (1) (tightening torque: 6 Nm). — 6 Nm (4.4 lb-ft)
5. Unplug electrical connector for contact switch.
6. Unclip contact switch from mounting.
7. Installation is carried out in reverse sequence.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Dismantling and assembling output shaft for 5th, 6th and reverse gears
• Removing and installing oil return line for turbocharger
• Repairing subframe, aluminium
• Removing and installing steering rack, RLD vehicle
• Adjusting lower locking wedges · 2 torque figures