Adjusting sunroof glass panel height — AUDI

🧭 Before you start

Fits: platform code 7DK

Don't miss

• When clipping-in trim frame only lift at front.

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Run glass panel to "“closed”" position.
2. Slide sliding headlining (1) to rear.
3. Slide trim frame (2) to rear (clipped in at front, also secured with velcro tape (3) and guided at rear by pegs).
4. Check and if necessary adjust parallel running: .
5. Loosen all six glass panel securing screws (floating alignment in roof aperture).

6. Carry out height adjustment of glass panel at front and rear on both sides as follows:
7. When doing this initially only tighten the front and rear securing screw on each side. Torque setting: 5 Nm. — 5 Nm (3.7 lb-ft)
8. Tighten glass panel centre securing screws. Torque setting: 5 Nm. — 5 Nm (3.7 lb-ft)
9. Slide trim frame forwards and clip in. [Note: When clipping-in trim frame only lift at front.]

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing fresh air intake · 4 torque figures
• Servicing subframe – Audi Q7
• Removing and installing track rod · 3 torque figures
• Removing and installing fuel tank shut-off valve – Audi A3 · 1 torque figures
• Removing and installing fuel tank - vehicles with front-wheel drive