Adjusting soft top: Audi TT Mk1
Step-by-step adjusting soft top for the Audi TT Mk1: 7 steps, 1 torque figure. What to remove, what to tighten and to how many Nm, what to check after.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi TT Mk1 (8N)
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 20 Nm (15 lb-ft) | Tighten hexagon bolts at main mounting |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- First determine dimension at locking element (1) by which soft top has to be moved.
- To adjust soft top in longitudinal direction, loosen hexagon bolts (1) (left and right) at main mounting (2).
- Move main mounting (1) of soft top as determined earlier using markings (arrow) on body (2).
- Tighten hexagon bolts at main mounting to 20 Nm. — 20 Nm (15 lb-ft)
- Remove trim for roof frame General body repairs, interior70.
- To adjust height of soft top at front you can move locking element (1) up or down.
- Markings (arrows) are provided to enable accurate height adjustment.
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Testing AC compressor signal and AC compressor shut-off
- Test solenoid valve 1 for activated charcoal filter
- Testing boost pressure - engine code AFN, AHH – Audi 1.9 TDI
- Testing exhaust gas recirculation > 06.97 – Audi 1.9 TDI
- Checking of heated rear window -Z1
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.