Adjusting headlight installation position, headlight with H7 bulb, vehicles up to model year 2010 — AUDI

🧭 Before you start

Fits: VW Caddy III (2K, 2004–2015); platform code 2C0

Don't miss

• Check headlight installation position to ensure gaps are even; correct if necessary.
• If a headlight is removed or adjusted to fit more accurately to the vehicle body, it must be aligned following such measures .

📋 Procedure

1. Switch off ignition and all electrical loads, and pull out ignition key.
2. Loosen and release the bolts and retaining hooks on the relevant side and pull bumper off bumper guide until all securing bolts are accessible General body repairs, exterior63Front bumper, up to 2011.
3. Unscrew securing bolts (arrows) and remove guide (1).
4. Loosen (arrows) at bottom of headlight.
5. Loosen bolts (arrows) at top of headlight.

6. Adjust shut lines/flushness to body by pushing in or pulling out alignment bush (arrow).
7. Tighten all securing bolts and nuts to specified torques given in assembly overview .
8. Check headlight installation position to ensure gaps are even; correct if necessary.
9. Fit bumper cover in reverse sequence.
10. Check functions of headlight. [Note: If a headlight is removed or adjusted to fit more accurately to the vehicle body, it must be aligned following such measures .]

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Checking fuel system pressurisation pump G6, vehicles with 3.0 ltr. (V6) or 4.2 ltr. (V8) engine from 06.2010 onwards
• Removing and installing air quality sensor G238/humidity sender in fresh air intake duct G657
• Removing and installing temperature flap control motor V68
• Checking neck heating
• Checking rear seat heating