Adjusting camber at rear wheels — AUDI
Adjusting camber at rear wheels on Audi: 8 steps. What to remove, in what order, and what to check after.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: platform code 42
Don't miss
- The maximum adjustment range is 90° to the left or right of the centre position.
📋 Procedure
- Removing and installing rear noise insulation 66.
- Removing and installing front noise insulation 66.
- If fitted: Removing and installing rear right Tyre Pressure Monitoring System aerial R62 with retaining bracket .
- Remove nut (A) on bolt connection between lower wishbone and mounting bracket and loosely screw on new nut.
- Adjust camber by turning eccentric bolt (B). [Note: The maximum adjustment range is 90° to the left or right of the centre position.]
- Tighten nut (A).
- Tightening torques
- Check camber value again after tightening nut (A).
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.