Adjusting bottom locking wedges — AUDI

🧭 Before you start

Fits: platform codes 70A, 70B, 70C, 70E, 70H, 70J, 70K, 70L, 70M

📋 Procedure

1. Unscrew load sill cover.
2. Removing rear roof pillar trim General body repairs, interior70Pillars and side panel trims
3. Slacken left locking wedge (2).
4. Close left wing door. When this is done, the locking wedge (1) is aligned by the pin (2).
5. Press wing door from the outside against the vehicle and tighten bolt (3).

6. Open wing door and tighten second bolt.
7. Slacken right locking wedge (3).
8. Close right wing door with left wing door closed. When this is done, the locking wedge (1) is aligned by the pin (2).
9. Press right wing door from the outside against the vehicle far enough until both wing doors are aligned with the outer edge.
10. Tighten bolt (3).
11. Open right wing door and tighten second bolt.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing seat side trim (sill side) - front seat (with manual adjustment)
• Removing and installing split rear seat backrest – Audi
• Removing and installing bracket/hinges for centre armrest - fixed rear seat backrest
• Removing and installing hinges - Avant – Audi A4 B8
• Removing and installing operating cable for door lock – Audi