5-speed manual gearbox 01A, four-wheel drive — Servicing cover for centre differential, removing and installing centre differential — AUDI

🧭 Before you start

Fits: Audi A4 Cabriolet B6/B7 (8H), Audi A4 B6/B7 (8E)

• Special tools named: puller

📋 Procedure

1. Remove circlip (A).
2. Screw an M8 bolt into thread of sealing cap (B).
3. Pull out sealing cap (B) using bolt.
4. Bend open circlip and pull out flange shaft.
5. When inserting flange shaft, fit circlip at the same time.

6. Position thrust piece 3002 directly on centre differential through opening (arrow).
7. Press ball bearing on as far as stop.
8. Remove circlip before pressing out bearing.
9. Fit circlip after pressing in bearing.
10. Both needle bearings in the centre differential are removed with the same puller.
11. Both needle bearings in the centre differential are pressed in with the same special tool.
12. Lightly oil outer circumference of oil seal.
13. Pack space between sealing lip and dust lip half-full with sealing greaseG 052 128 A1.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing fresh air and air recirculation flap control motor V154 or air recirculation flap control motor V113
• Renewing seal between output flange bevel box, vehicles as of model year 2010
• TT_3.2 BHE/BPF Ancillary drive belt
• Parking brake fail
• Connecting fault reader V.A.G 1551 and selecting functions