P3579 — ETS emission related
Documented by: VOLVO
P3579 means: ETS emission related. That is the standard definition — what actually triggered it on a given car depends on the engine.
Code family
P3xxx is reserved section used by some manufacturers for specific diagnostics.
Severity
Reserved section — the meaning is manufacturer-defined; a generic scanner rarely gives the full picture.
General steps
These apply to most OBD codes and are the right starting point before replacing anything. They are not specific to this code — for that, ask me about your car below.
- Read ALL codes, not just this one — other active codes often give a better picture of the real root cause.
- Clear the code with a scanner and check if it returns after driving. Sometimes it is a one-off glitch.
- Check freeze frame data — it shows engine state at the moment the code triggered (RPM, temp, speed, load).
- Visual inspection: vacuum hoses (cracks), electrical connectors (oxidation), air filter, visible leaks.
- For persistent codes — measure with multimeter and oscilloscope on the sensor/actuator the code points to.
- Compare sensor readings against OEM specifications for the specific engine.
That is what holds for P3579 in general. From here it depends on your engine — tell me which car it is and what it does, and I will give you the steps for it: real procedures, torque figures and diagrams instead of general advice.
Why TorqFix for your car?
Above is what the code means and why it appears. TorqFix goes further — it gives you specific procedures, torque values, wiring diagrams and pinouts for your exact engine, not generic steps for every car. Real workshop data (127,000+ diagrams, 10,000+ procedures), interpreted by AI in your language.
Free with an account: 4 questions per day · drawings are Pro. Signing up takes twenty seconds and needs no card.
Code breakdown
🔧 Related repair procedures
- AUDI: Testing twin-spark ignition system with two ignition coils
- AUDI: Testing ignition coils with output stages
- VW: Checking ignition coils with final output stage
- AUDI: Checking output stages for ignition coils
- AUDI: Checking output stage for ignition coil
- AUDI: Testing power output stages for ignition coils
- VW: Checking glow plugs
- VW: Removing, installing and checking ceramic glow plugs
- AUDI: TDI injection and glow plug system (6-cyl.) — Fault table: fault codes 00513...00671
- AUDI: TDI injection and glow plug system (6-cyl.) — Fault table: fault codes 00741...65535
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
The same code can mean different things on different makes. Match the meaning to your make before acting on it.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →