P22B7 — O2 Sensor Pumping Current Trim Circuit High Bank 1 Sensor 2
P22B7 is stored when the ECU sees signal too high on oxygen sensor (bank 1, sensor 2). That describes how the circuit is behaving, not which part has failed — the wiring, the connector and the component itself can all produce it, which is why the checks below start with the cheapest.
Common causes
The cause is almost always one of a few things. Here they are — P22B7 rarely comes from anything outside this list:
- Open ground for the sensor, letting the signal float up
- Signal line shorted to a supply voltage
- Sensor failed open, which the module reads as maximum
- Connector fault interrupting the return path
Where to start
In the order a sensible mechanic would work — the cheap checks first, the expensive replacements only after:
- Read the live value and compare with what the conditions should produce
- Check the sensor ground continuity back to the module
- Unplug the sensor: if the reading changes, the wiring is intact and the sensor is suspect
- Inspect the connector for corrosion or a spread terminal
- Replace the sensor once ground and signal wiring are confirmed good
That is what holds for P22B7 in general. From here it depends on your engine — tell me which car it is and what it does, and I will give you the steps for it: real procedures, torque figures and diagrams instead of general advice.
Why TorqFix for your car?
Above is what the code means and why it appears. TorqFix goes further — it gives you specific procedures, torque values, wiring diagrams and pinouts for your exact engine, not generic steps for every car. Real workshop data (127,000+ diagrams, 10,000+ procedures), interpreted by AI in your language.
Free with an account: 4 questions per day · drawings are Pro. Signing up takes twenty seconds and needs no card.
Code breakdown
🔧 Related repair procedures
- AUDI: Removing and installing front exhaust pipe (left-side) with starter catalytic converter and main catalytic converter on vehicles with automatic gearbox 01V
- VW: Front exhaust pipe with catalytic converters in the cylinder head - installation sequence
- AUDI: Checking Lambda probes and Lambda control after catalytic converter - vehicles with engine code letters "“ARE”", "“AZA”" and "“BES”"
- VW: Removing and installing Lambda probe 3 after catalytic converter G287 and Lambda probe 4 after catalytic converter G288
- VW: Removing and installing catalytic converter
- AUDI: Removing and installing front exhaust pipe (right-side) with catalytic converter - vehicles with multitronic gearbox
- AUDI: Checking Lambda probe and Lambda control before catalytic converter
- AUDI: Removing and installing front exhaust pipe (left-side) with starter catalytic converter and main catalytic converter (vehicles with automatic gearbox)
- AUDI: Removing and installing starter catalytic converter
- AUDI: Removing and installing front exhaust pipe (left-side) with starter catalytic converter and main catalytic converter (vehicles with manual gearbox)
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
The same code can mean different things on different makes. Match the meaning to your make before acting on it.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →