P1999 — 2 documented meanings by make

P1999 does not mean the same thing on every car — manufacturers reuse the number for different faults. 4 makes document it: Audi, Mercedes-Benz, SEAT, Skoda. Find your make below.

P1999 on Audi, SEAT, Skoda

On Audi, SEAT, Skoda vehicles P1999 is documented as: Friction too high, exhaust cam adjustment bank 2. P1999 is stored when the ECU sees signal too high on the circuit named in the code (bank 2). That describes how the circuit is behaving, not which part has failed — the wiring, the connector and the component itself can all produce it, which is why the checks below start with the cheapest.

Usually one of: Open ground for the sensor, letting the signal float up; Signal line shorted to a supply voltage; Sensor failed open, which the module reads as maximum; Connector fault interrupting the return path.

Check first, cheapest first:

1. Read the live value and compare with what the conditions should produce
2. Check the sensor ground continuity back to the module
3. Unplug the sensor: if the reading changes, the wiring is intact and the sensor is suspect
4. Inspect the connector for corrosion or a spread terminal
5. Replace the sensor once ground and signal wiring are confirmed good

Related Audi, SEAT, Skoda codes:

P1999 on Mercedes-Benz

On Mercedes-Benz vehicles P1999 is documented as: Load limit is active. P1999 is stored when the ECU sees below threshold on the circuit named in the code. That describes how the circuit is behaving, not which part has failed — the wiring, the connector and the component itself can all produce it, which is why the checks below start with the cheapest.

Usually one of: The monitored part has degraded rather than failed; An upstream fault is loading the part beyond its design; Sensor used to judge the threshold is itself inaccurate; Normal wear reaching the end of its service life.

Check first, cheapest first:

1. Fix any other stored codes first — this class is very often a consequence, not a cause
2. Verify the sensors that judge the threshold before replacing the expensive part
3. Check for leaks or restrictions that would make a healthy part read as failed
4. Compare readings before and after the component
5. Replace the component once it is proven to be the one that has degraded

Related Mercedes-Benz codes:

Which one is yours

A generic OBD reader gives you the number, not which of these meanings your manufacturer assigned to it. To get to the specific one:

1. Use a brand-specific scanner — VCDS for VAG, INPA or ISTA for BMW, XENTRY for Mercedes, Forscan for Ford. It shows the manufacturer's own text rather than the generic one.
2. Read all stored codes together — the neighbouring ones usually point at which system is involved and narrow the list.
3. Check freeze-frame data: the RPM, temperature and load at the moment it triggered indicate which system was active.
4. If you have no brand scanner, tell me the make and model below and I will tell you which of these applies to your car.

Code family

P1xxx is manufacturer-specific code (VW/Audi, BMW, Mercedes, Toyota etc. have different meanings for the same code number).

Severity

Manufacturer-specific codes need a brand scanner (VCDS for VAG, INPA for BMW, STAR for Mercedes).

That is what holds for P1999 in general. From here it depends on your engine — tell me which car it is and what it does, and I will give you the steps for it: real procedures, torque figures and diagrams instead of general advice.