P0414 — Short circuit in secondary air injection valve
The code indicates an electrical short in the secondary air injection system's switching valve. This valve helps reduce emissions by injecting air into the exhaust to burn off pollutants. A short circuit means the valve's wiring or internal coil is faulty, causing the engine control unit to detect an electrical problem.
Common causes
The cause is almost always one of a few things. Here they are — P0414 rarely comes from anything outside this list:
- Damaged or frayed wiring to the valve
- Faulty secondary air injection switching valve
- Corroded or loose electrical connectors
- Blown fuse related to the air injection system
Where to start
In the order a sensible mechanic would work — the cheap checks first, the expensive replacements only after:
- Inspect and repair wiring and connectors
- Check and replace blown fuses
- Test valve operation and replace if faulty
- Clear codes and retest system
That is what holds for P0414 in general. From here it depends on your engine — tell me which car it is and what it does, and I will give you the steps for it: real procedures, torque figures and diagrams instead of general advice.
Why TorqFix for your car?
Above is what the code means and why it appears. TorqFix goes further — it gives you specific procedures, torque values, wiring diagrams and pinouts for your exact engine, not generic steps for every car. Real workshop data (127,000+ diagrams, 10,000+ procedures), interpreted by AI in your language.
Free with an account: 4 questions per day · drawings are Pro. Signing up takes twenty seconds and needs no card.
Code breakdown
🔧 Related repair procedures
- AUDI: Removing and installing front exhaust pipe (right-side) with starter catalytic converter and main catalytic converter (vehicles with automatic gearbox)
- VW: Removing and installing catalytic converters
- VW: Removing and installing starter catalytic converter
- VW: Checking Lambda probe and Lambda control before catalytic converter
- AUDI: Removing and installing front exhaust pipe with catalytic converter
- AUDI: Removing and installing front exhaust pipe with starter catalytic converter
- AUDI: Removing and installing front exhaust pipe (right-side) with catalytic converter - vehicles with manual gearbox
- AUDI: Checking lambda probe and lambda control downstream of catalytic converter
- AUDI: Removing and installing front exhaust pipe (right-side) with starter catalytic converter and main catalytic converter - vehicles with manual gearbox or multitronic gearbox 01J
- AUDI: Removing and installing catalytic converter
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
The same code can mean different things on different makes. Match the meaning to your make before acting on it.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →