P0213 — Problem with cold start fuel injector operation
The engine's cold start injector 1 is not working properly, causing issues during engine startup in cold conditions. This injector helps provide extra fuel to start the engine smoothly when it's cold.
Common causes
The cause is almost always one of a few things. Here they are — P0213 rarely comes from anything outside this list:
- Faulty cold start injector
- Wiring or connector issues to the injector
- Blown fuse related to injector circuit
- Engine control unit malfunction
- Clogged or dirty injector
Where to start
In the order a sensible mechanic would work — the cheap checks first, the expensive replacements only after:
- Check and repair wiring and connectors
- Test and replace blown fuses if needed
- Clean the cold start injector
- Replace faulty cold start injector
- Inspect engine control unit if problem persists
That is what holds for P0213 in general. From here it depends on your engine — tell me which car it is and what it does, and I will give you the steps for it: real procedures, torque figures and diagrams instead of general advice.
Why TorqFix for your car?
Above is what the code means and why it appears. TorqFix goes further — it gives you specific procedures, torque values, wiring diagrams and pinouts for your exact engine, not generic steps for every car. Real workshop data (127,000+ diagrams, 10,000+ procedures), interpreted by AI in your language.
Free with an account: 4 questions per day · drawings are Pro. Signing up takes twenty seconds and needs no card.
Code breakdown
🔧 Related repair procedures
- LAND ROVER: TD5 fuel injector removal
- AUDI: Removing and installing injectors, FSI engines
- VW: Renewing seals on injectors
- VW: Removing and installing alternator, 2.0 l TDI unit injector engine
- AUDI: 4-cylinder TDI unit injector engine (2.0 ltr. 4-valve), mechanics — Installing engine
- VW: Renewing Teflon seal and support washer on injector
- VW: Checking and adjusting position of pump plungers in unit injectors
- VW: 1.2 TDi CFWA Injector remove install
- VW: Removing and installing injectors, Continental
- AUDI: Removing and installing unit injector
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
The same code can mean different things on different makes. Match the meaning to your make before acting on it.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →