C1078 — Tyre revolutions range/performance

C1078 is stored when the ECU sees range or performance on the circuit named in the code. That describes how the circuit is behaving, not which part has failed — the wiring, the connector and the component itself can all produce it, which is why the checks below start with the cheapest.

Common causes

The cause is almost always one of a few things. Here they are — C1078 rarely comes from anything outside this list:

• Sensor reading is inside its electrical range but does not match reality
• Contamination or deposits changing what the sensor sees
• A mechanical fault upstream that the sensor is correctly reporting
• Sensor drifted with age without failing outright

Where to start

In the order a sensible mechanic would work — the cheap checks first, the expensive replacements only after:

1. Compare the live value against a second sensor or a known-good figure — this code is about plausibility, not a dead circuit
2. Look for the mechanical cause first: leaks, restrictions or wear that would genuinely produce this reading
3. Clean the sensor if it is the type that fouls
4. Check freeze-frame data to see under what conditions it triggered
5. Replace the sensor only after the mechanical side is ruled out

That is what holds for C1078 in general. From here it depends on your engine — tell me which car it is and what it does, and I will give you the steps for it: real procedures, torque figures and diagrams instead of general advice.