C1007 — Brake fluid level input circuit low

C1007 is stored when the ECU sees signal too low on the circuit named in the code. That describes how the circuit is behaving, not which part has failed — the wiring, the connector and the component itself can all produce it, which is why the checks below start with the cheapest.

Common causes

The cause is almost always one of a few things. Here they are — C1007 rarely comes from anything outside this list:

• High resistance in the supply or ground path, dragging the signal down
• Corroded connector adding resistance the module reads as a low reading
• Sensor drifted out of tolerance with age
• Partial short to ground somewhere in the signal line

Where to start

In the order a sensible mechanic would work — the cheap checks first, the expensive replacements only after:

1. Read the live value on a scanner and compare with a known-good reading
2. Clean and re-seat the connector, then re-test before replacing anything
3. Check the ground point for that circuit — a poor ground causes this far more often than a bad sensor
4. Measure the sensor against specification with the connector back-probed
5. Replace the sensor only once the wiring and ground have been ruled out

That is what holds for C1007 in general. From here it depends on your engine — tell me which car it is and what it does, and I will give you the steps for it: real procedures, torque figures and diagrams instead of general advice.